Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

alarm history with printjob

Created by: plenc at: 10/6/2008 9:25 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

10/6/2008 9:25 AM	Rate (0)
plenc Posts: 37 Rating: (0)	Hello, I want to make alarm history with cyclically printjob. The list of occured allarms sholud be print once a day. What is more it should consist all alarms which happed in the day.Even if operator acknowledge the alarm (to turn machine in run mode) the fact that this alarm occured have to be printout. Best Regards, P.
plenc Posts: 37 Rating: (0)
Suggestion To thank Quote Answer

10/6/2008 12:47 PM	Rate (0)
rit03 Silver Member Joined: 6/13/2006 Last visit: 2/11/2023 Posts: 341 Rating: (24)	plenc Hello, I want to make alarm history with cyclically printjob. The list of occured allarms sholud be print once a day. What is more it should consist all alarms which happed in the day.Even if operator acknowledge the alarm (to turn machine in run mode) the fact that this alarm occured have to be printout. Best Regards, P. You can specify the cyclical printjob in propoerties. To report all alarmCameIN even ifit was acknowledged or clear, you need to define selection as STATE IN(1) in alarm dynamic table of report. regards,rit03

Suggestion To thank Quote Answer

10/6/2008 2:58 PM	Rate (0)
plenc Posts: 37 Rating: (0)	...I know how to set the cyclicaly print job but how to set the alarm list? Could You give some advice? Thanks, P.
plenc Posts: 37 Rating: (0)
Suggestion To thank Quote Answer

10/6/2008 4:00 PM	Rate (0)
rit03 Silver Member Joined: 6/13/2006 Last visit: 2/11/2023 Posts: 341 Rating: (24)	plenc ...I know how to set the cyclicaly print job but how to set the alarm list? Could You give some advice? Thanks, P. Thats what I advice you. To report all all alarms that was active , you need to select STATE IN (1) in"Selection" listof connect tab in Dynamic table ofalarm controlin report layout. Regards rit03

Suggestion To thank Quote Answer

10/8/2008 4:11 PM	Rate (0)
plenc Posts: 37 Rating: (0)	Hi, I couldn't fint the properties about which You wrote. But could i cyclicaly start the "@Report Alarm Logging RT OnlineMessages New" to cyclicaly printout all the allarms occured after last printout? hat is more in standart settings i can't see possibility to add a column with "@currentuser". How to add it to the layout? Best Regards, P.
plenc Posts: 37 Rating: (0)	Last edited by: plenc at: 10/8/2008 4:26 PM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on