Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

analog input overflow

Created by: Import-User-1 at: 4/14/2014 8:52 AM (2 Replies)

Rating (0)

Thanks 1

3 Entries

4/14/2014 8:52 AM	Rate (0)
Import-User-1 Posts: 3609 Rating: (29)	Import of a Technical Question of the User shanmugam shanmugam Hi. All... In analog input module 6ES7331-7KF02-0AB0 am having problem.. In module information -standard dignostic of module am getting error message as EXTERNAL ERROR FAULTY MODULE NO EXTERNAL AUXILARY VOLTAGE Now can you please tell me i have configured properly it as 2 wire thermocouple type... I have connected 2 pin M+of the sensor and M- to pin no3.. Same has been done for all input ... Am getting error as 7fffh... ie A OVERFLOW VALLUE... Regards By, Shan.
Import-User-1 Posts: 3609 Rating: (29)
Suggestion To thank Quote Answer

4/15/2014 9:24 AM	Rate (0)
Jens_app Gold Member Joined: 1/5/2011 Last visit: 6/15/2024 Posts: 815 Rating: (123)	Import-User-1 Import of a Technical Question of the User shanmugam shanmugam Hi. All... In analog input module 6ES7331-7KF02-0AB0 am having problem.. In module information -standard dignostic of module am getting error message as EXTERNAL ERROR FAULTY MODULE NO EXTERNAL AUXILARY VOLTAGE Now can you please tell me i have configured properly it as 2 wire thermocouple type... I have connected 2 pin M+of the sensor and M- to pin no3.. Same has been done for all input ... Am getting error as 7fffh... ie A OVERFLOW VALLUE... Regards By, Shan. Hi Shan, As far as I can see, the wiring of the thermocoupleis correct. Make sure to have +24VDC on pin 1 (L+) and 0VDC on pin 20 (M), that may cause the "NO EXTERNAL AUXILARY VOLTAGE" error. Make sure your module setting (the square block inside your module) is set to A and in your hardware configuration you have selected the correct type of thermocouple. There's also following note I read in the manual: -An interconnection of M- and MANA is prohibited when using grounded thermocouples. In this case, you must ensure that low-resistance equipotential bonding is in place so that the permitted common-mode voltage is not exceeded. -Interconnect M- and MANA when using non-grounded thermocouples For wiring diagram see manual page 375: https://support.automation.siemens.com/WW/llisapi.dll?query=s7300+module+dat&func=cslib.cssearch&content=adsearch%2Fadsearch.aspx%3Ftab%3D2&lang=en&siteid=csius&objaction=cssearch&searchinprim=_searchinprim_&nodeid=99&x=16&y=8&cssearchengine=NEW&x=0&y=0 If all is wired correctly and set up correctly re-test, your SF should be gone. Kind regards, Jens
	Keep it simple and on-topic. A simple straight-to-the-point answer is often of more quality than a complicated one.
Suggestion To thank Quote Answer

4/16/2014 2:54 PM	Rate (0)
shanmugam Posts: 25 Rating: (0)	thanks for your kind reply..... i have found, its a module fault..
shanmugam Posts: 25 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Jens_app

|

Share this page:

Share this page on...

Follow us on