Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

application in Servo V90 drive

Created by: Nitin Parmar at: 6/3/2014 8:24 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

6/3/2014 8:24 AM	Rate (0)
Nitin Parmar Advanced Member Joined: 9/23/2013 Last visit: 10/20/2024 Posts: 47 Rating: (0)	sandy_kalsi Hello Everybody I want to use this MM440 drive for cutter motor for online sheet cut to length. For this application i have to use 1st encodure as a main sheet line to sence length & speed refrence to the drive and second encodure in motor for close loop mode for cutting Sheet accuracy . The 1st encodure sence the line speed and length and by the electronic gearing the speed refrence is given to the cutter drive. This application is running in Eurotherm drive. Please help me to run this application in Siemens MM440 drive. Thanks & Regards SandyKalsi Dear Experts, Is it possible in Servo V90 drive???
	Last edited by: CS Moderator at: 6/4/2014 1:17 PM new subject after splitting from /tf/WW/en/Posts/47774#top reference insterted
Suggestion To thank

6/4/2014 1:20 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 12/5/2024 Posts: 4114 Rating: (195)	closed cause question allready discussed within the existing threadcut to length application using Servo V90 drive. Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_V

Follow us on