Hello

How i can addressing "ASI slave " without using "AS-INTERFACE ADDRESSING UNIT"

KhanhLe

Hello

How i can addressing "ASI slave " without using "AS-INTERFACE ADDRESSING UNIT"

 Hi,

There are only two days to address the ASI Slaves.

1. If Auto addressing is enabled and devices are connected in the ASI network, the random ASI address will be assigned to the slave.

2. Is via the ASI Interface Addressing Unit. 

hello saravana

If i repalace a asi slave module in system by a new ASi slave module . Can new asi slave module auto addressing? and the address same the old adress or not?

KhanhLe

hello saravana

If i repalace a asi slave module in system by a new ASi slave module . Can new asi slave module auto addressing? and the address same the old adress or not?

 If it selected for Auto Addressing, It will assign with New address after replacing the module.

Hi,

You can browse for the accessible ASI devices from the ASI master device. 

Connect the slaves one by one and find the address. This procedure to be followed only for the first time installation. 

New question published by Chicão is split to a separate thread with the subject Communicating to PLC STEP7 300/400 with AS- Inteface network.

Best regards
Min_Moderator