Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Assigned Tool Locations in Magazine - Heller MCH-250 Siemens 840D

Created by: MTU_USA_MH at: 4/5/2012 9:23 PM (3 Replies)

Rating (1)

Thanks 1

4 Entries

4/5/2012 9:23 PM	Rate (0)
MTU_USA_MH Posts: 2 Rating: (0)	I am trying to speed up my process and have configured how I need the tools in the magazine to speed up tool changes (two operations/using some similar tools). But know I want to make it so my operators cant move these tools. Is there a way to make a tool have a fixed location in the tool changer? I have scanned through multiple manuals and cant find anything. Could someone please assist me in this matter. Thanks!
MTU_USA_MH Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

4/6/2012 9:19 AM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi As I understand you want that the operators can't change the position in the tool magazine or you want that the machine to put the tools in the same locations all the times a tool change occurs? How do you load the tools in the magazine? Your machine is using Tool Management? We need more information in order to help you. Good luck Nit
	Last edited by: Nit at: 4/6/2012 9:24 AM
Suggestion To thank Quote Answer

4/6/2012 7:02 PM	Rate (1)
SteveA Posts: 297 Rating: (41)	If you want the control to return the tool in the spindle to the location it came from, there are two methods. You can set bit 6 in $TC_TP8 fore each tool to mark the tool as fixed location coding. This setting can be made in the Tool Details screen. It is normally set to Variable, but you can change it to Fixed. You can also set the magazine to fixed location coding. Then, all tools loaded into the magazine will be considered fixed location coded. There is a screen in the tool management setup that lets you make this setting and create a config file, but if you do that and load the file, you will delete all tool data. You can change bit 6 of $TC_MAP3[mag number] using an MDI program. You should read the current value and add 64, then write it back. Both these variables are described in the Function Manual, Tool Management, in Doc on CD. HTH, SteveA
SteveA Posts: 297 Rating: (41)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users MTU_USA_MH

4/11/2018 9:22 AM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 12/7/2023 Posts: 7572 Rating: (156)	New question published by 2 of 3 is split to a separate thread with the subject Want to move to the toolchange position in all three axis. Best regards Jen_Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Jen_Moderator
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on