Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

automatic integration

Created by: BilgimmSS at: 7/1/2012 9:03 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

7/1/2012 9:03 PM	Rate (0)
BilgimmSS Posts: 6 Rating: (0)	hi friends.if is it possible i want some information about automatic integration. what is it and how can i use it.because i have same problem with f-cpu.i am using a operator pendand and it has two channels.i use two operator pendand.it should do that the operator press both of them motor driver activated and drive motor.but when i press pendands f-cpu transition to stop mode.if you help make me happy.thank you.
BilgimmSS Posts: 6 Rating: (0)	Last edited by: O_Moderator at: 7/3/2012 10:11 AM new subject after splitting from /tf/WW/en/Posts/17089#top
Suggestion To thank Quote Answer

7/10/2012 4:32 PM	Rate (0)
Gabriel de Oliveira Bronze Member Joined: 2/16/2011 Last visit: 7/8/2024 Posts: 229 Rating: (28)	Hello We need more information like.. What the error informatio? How did you configurate the chanel? NA + NA , or NA + NF? How much is the discrepancy time? May be the error is Discrepancy and increase the time helps. (But in this case the CPU will not go to STOP I think See Sample: Safety: Two-Hand Control Panel with Integrated Emergency Stop in Category 4 according to EN 954-1: 1996 (with evaluation according to EN 62061 and EN ISO 13849-1: 2006) You can find more details in these Siemens manuals: SIMATIC Industrial Software S7 F/FH Systems - Configuring and Programming SIMATIC Industrial Software Safety Engineering in SIMATIC S7 Regards
	Gabriel de Oliveira It Works? Rate It.
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on