Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

boot pcu 20

Created by: cumnewtec at: 9/6/2011 3:32 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

9/6/2011 3:32 PM	Rate (0)
cumnewtec Posts: 2 Rating: (0)	we have a problem with the boot of the machine when the machine starts the following message appears CMOS Checksum error Defaults loeded CMOS battery failed and it stop in loaded of SHOPTURN auto test. we have in our machin the PCU 20.
cumnewtec Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

9/6/2011 7:10 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	Hello.... Fine you have PCU20 does it is connected with 840D NCU or 810D CCU.... you should not get the error of CMOS looks like there hardware fault in PCU20...... Check condition in the Drive side as well as in NCU -CCU... Check it out.... Regards, Prakash
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

9/6/2011 9:10 PM	Rate (0)
cumnewtec Posts: 2 Rating: (0)	hello I did not explain my problem. the machine starts and it stop loaded in SHOPTURN auto test. this message appears qwk 004 token err : 022 015 I send a picture to explain we have 810D best regards Attachment CIMG932.JPG (136 Downloads)
cumnewtec Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

9/7/2011 6:14 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	Hello.... The problem looks like there is problem in your HMI software.You need to renistall HMI as well Shopturn software and check.... Regards, Prakash
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on