Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Button Focus

Created by: BenB at: 9/25/2013 5:38 PM (4 Replies)

Rating (0)

Thanks 1

5 Entries

9/25/2013 5:38 PM	Rate (0)
BenB Advanced Member Joined: 3/5/2013 Last visit: 7/25/2024 Posts: 21 Rating: (0)	Hello, Is there any way to disable the button focus on an HMI. Whenever I press a button a dotted line appears and stays on the last button I have pressed. Normally its not a big deal, but I have been using invisible buttons and I would like the focus to not show whenever one is pressed. Thank you, BenB

Suggestion To thank Quote Answer

9/25/2013 6:46 PM	Rate (0)
rdoliveira Gold Expert Joined: 4/26/2012 Last visit: 1/24/2025 Posts: 1592 Rating: (173)	Set to 0 focus width. Attachment focus.jpg (776 Downloads)
	"Always make a backup before and check the best time before testing." Obrigado.
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users zakrzewc

9/25/2013 7:03 PM	Rate (0)
BenB Advanced Member Joined: 3/5/2013 Last visit: 7/25/2024 Posts: 21 Rating: (0)	Thank you for the reply, but I don't have that option. I am using TIA Portal Step 7 Basic V12 SP1. See attached picture. Attachment focus.JPG (491 Downloads)

Suggestion To thank Quote Answer

9/25/2013 7:16 PM	Rate (0)
rdoliveira Gold Expert Joined: 4/26/2012 Last visit: 1/24/2025 Posts: 1592 Rating: (173)	sorry I have version "Professional"
	"Always make a backup before and check the best time before testing." Obrigado.
Suggestion To thank Quote Answer

9/27/2013 11:02 AM	Rate (0)
Tweety Posts: 3037 Rating: (192)	BenB Thank you for the reply, but I don't have that option. I am using TIA Portal Step 7 Basic V12 SP1. See attached picture. you can not do this with a Basic Panel. Tweety
Tweety Posts: 3037 Rating: (192)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Adv Picture Controls

Follow us on