1500T is 1000 point .

SIMOTION not linmit , is very good !

hello,

i have a module axis problem .

module axis is 0~360 ,can use any command edit it to 0~720 ?

TechWing

hello,

i have a module axis problem .

module axis is 0~360 ,can use any command edit it to 0~720 ?

 You can define your axis' Modulo as 720. But if for some reasons you can't, you can use a virtual axis that is geared 1:2 to your master and link 1:1 your cammed axis to the virtual...

Obviously this requires a decent degree of careness in repositioning in order to always maintain the correct position between the master, the virtual and the final axis ;)

If you can follow the tip of jacek it's less tricky

i think CAM master module is only 0~360 fine .

scaling cam ,what is it function ,can it change axis postion at CAM ?

eg...

master zoom out ,slave is finish cam is shorten ? 、and slave zoom in ,slave is finish cam postion is reduce ?