Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

CAN bus communication

Created by: Celio Silva at: 4/2/2008 10:15 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

4/2/2008 10:15 PM	Rate (0)
Celio Silva Posts: 36 Rating: (2)	Hello, anybody know what is the communication card needed to comunicate on CAN-bus using a S7-300 system? or where can I find this information ? thanks a lot !
Celio Silva Posts: 36 Rating: (2)	Last edited by: Celio Silva at: 4/3/2008 2:33 PM
Suggestion To thank Quote Answer

4/3/2008 1:24 AM	Rate (0)
J_Bell Posts: 5822 Rating: (412)	Hello, I am affraid that there is no direct CAN Bus Interface for SIMATIC S7 available, at least not by SIEMENS. If you want you may use a Gateway on PROFIBUSDP Slaveor PROFINET IO to get a CAN Interface of some way. You may have to check the Internet about such a Gateway. Best regards J_Bell
J_Bell Posts: 5822 Rating: (412)
Suggestion To thank Quote Answer

4/3/2008 2:30 PM	Rate (0)
Celio Silva Posts: 36 Rating: (2)	Thanks J_Bell, I found this equipment : http://www.profibus.com/member/esd_gmbh/products/article/6611/ it´s a network gateway, now I´ll try to find a distributor near me . Best Regards !
Celio Silva Posts: 36 Rating: (2)
Suggestion To thank Quote Answer

3/16/2009 11:35 AM	Rate (0)
inos Posts: 1 Rating: (0)	Hi Silva that gateway communication is working well? If you don't mind please share to me , due to I have same problem to make communication betweens7-400 to CAN J1939 Thanks a lot Rgds, Inos
inos Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

3/16/2009 5:49 PM	Rate (0)
Celio Silva Posts: 36 Rating: (2)	Hello Inos, Unfortunately, we did not use this equipment because our customer decided to change the old VFD for another with profibus interface ! Sorry for not being able to help you this time ! Best regards and good luck ! Célio Silva
Celio Silva Posts: 36 Rating: (2)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on