Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Can I store the setpoint in memory, when I switch off the logo and on again?

Created by: mebots71 at: 4/20/2022 4:10 PM (2 Replies)

Rating (1)

Thanks 0

3 Entries

4/20/2022 4:10 PM	Rate (0)
mebots71 Member Joined: 2/3/2022 Last visit: 12/30/2022 Posts: 10 Rating: (0)	[snip] Two question more: Can I store the setpoint in memory, when I switch off the logo and on again? [snip] Thank you Martijn ------------------------------------------------------------------------------------------ Split from Sinamics V20 and Logo! - Speed control.
	Last edited by: Jen_Moderator at: 04/21/2022 05:59:18 New subject after splitting. Division of question into separate topics.
Suggestion To thank Quote Answer

4/20/2022 4:16 PM	Rate (1)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 12/11/2023 Posts: 31603 Rating: (3930)	If you write via TDE directly in a parameter of a block (e.g. mathematical instruction), then remain this value by power off. The parameter values were stored in a flash memory. [snip]
	Last edited by: Jen_Moderator at: 04/21/2022 06:00:30 Division of answers into separate topics.
Suggestion To thank Quote Answer

4/21/2022 5:57 AM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 12/7/2023 Posts: 7572 Rating: (156)	New question published by mebots71 is split to a separate thread with the subject If I press F1 I want to goto screen x to do the settings, is this possible?. Best regards Jen_Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Jen_Moderator
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on