Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Can i use 313-2DP to communicate with S110?

Created by: Oscar_83PL at: 10/28/2009 2:40 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/28/2009 2:40 PM	Rate (0)
Oscar_83PL Bronze Member Joined: 10/22/2008 Last visit: 9/22/2024 Posts: 369 Rating: (5)	Hi, I used S120 before but now i would like to make project on S110 and i have some questions about differences between these two. [schnippschnapp] 3. Can i use 313-2DP to communicate with S110? [schnippschnapp] best regards
	Last edited by: O_Moderator at: 10/29/2009 11:29 AM new subject after splitting
Suggestion To thank Quote Answer

10/30/2009 7:24 AM	Rate (0)
BigBird Advanced Member Joined: 12/4/2007 Last visit: 1/5/2024 Posts: 26 Rating: (0)	Hello : I think you need the ssp of starter (s7T-config) in order to communicate betwen both t-cpu and s110 Here is link http://support.automation.siemens.com/WW/view/de/35533333 Best regards

Suggestion To thank Quote Answer

11/11/2009 6:27 PM	Rate (0)
hccong Posts: 5 Rating: (0)	Dear Oscar, You can use CPU 313-2DP to communicate with S110. First, you must add S110 GSD file in Step7 hardware config, and select message frame PZD that you want to communicate with S110 Second, in Starter, you must configure S110 message frame same with the configuration in Step7 hardware configure In CPU 313-2DP, you create a function block to send and receive data between S110 and CPU 313-2DP via these addresses Note: you must read S110 manual to make sure which address is control word and which address is status word of S110 Regards,
hccong Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on