Can not Simulation WinCC Pro V13 SP1 and S7-1200 PLC

Dear all Expert

I would like to ask you only think as my stupid but please give me advise for the problem. I am learning TIA portal V13 SP1 and start simulation project with WinCC Pro V13 SP1 and S7-1200. The capture here is my Simulation but un-success and the project I made. If you have time and experience so please give me advise how to solve my problem.

In attachment is project that I already reated for simulation

Thank in advance

Best regards

Sie-auto

...obsolete...

Hello,

the project works on my side without any problem.

I think you problem is the setting of PG/PC Interface.

Please check this settings in the Windowss Control panel -> set PG/PC Interface

here you must configure for S7ONLINE  -> PLCSIM S7-1200/S7-1500.TCPIP.1 

then it should work correctly.

Regards

Christoph