good morning

i have vision sensor microscan mv40 and plc siemens s7-1200 and i use tia portal v15 to program my plc. when i add gsd file from vision sensor. my plc eror. because my vision cant read in my plc. please help me.

when i search my device in accessible device in the network. my vision not found.

------------------------------------------------------------------------------------------
Split from PLC can't communicate with VS723.

Hello

Which IPs do you use? -> can you ping your PLC and the mv40 from PC?

What is written in the Diagnostic Buffer of the PLC?

Bye Murof

Hi,

did you already assign a Profinet Name to your io-device?

Regards,

Towome

HI, 

can you give me this step? i am not assign a profinet name to my io device 

regards 

kiky pradina yunior

Hi

I've connected my PC, PLC s7-1200 and Vision Sensor microscan MV 40 with each other through a switch over Profinet. Three of the two communications works.

- the communication between the PC and PLC works fine
- the communication between the PC and Vision Sensor also works fine (I can see the images and program the camera).
- the communication between the PLC and Vision Sensor however doesn't work. The PLC can't see the camera.

They are all in the same range and subnet. (192.168.0.0 and 255.255.255.0). In theory it should work.

i use tia portal v15.

Does anyone know what the problem is and how i can fix this.

Greetings
kiky pradina yunior

hello

i use ip 

vision : 192.168.0.2

plc: 192.168.0.1

hmi : 192.168.0.4

pc : 192.168.0.3

 i can ping my plc and vision using my pc. but my vision not detect in my plc

best regard 

kiky pradina yunior