İ have a cb1241 for communication to G110. so I can't communicate with the driver. İ'am triyng for 3 days:(

Searching in forum and I try every samples and solution but there is no action. 

3 wire connection T/RA and T/RB AND M Shielded and length is 1meter.

TrA =>8.Pin TrB=>9.pin M=>10.Pin

TxD and RxD blinking. Any one can help me please?

Hi ,

pls upload the pic with error code ...by assigning a word to uss drive fb and uss port..

and try with lower baud rate of 9.600kb/s

RxD is not flashing TxD is normal. İ try to lower rates but there is no answer from driver.

T/RA => driver 8. port

T/RB => driver 9.port

M=> driver 10.port

this connection is it true ?

I want to control the speed and start, stop command. just I need this.

USS Drive Control DB in Main OB with the USS Port. İ think something is wrong with my program.

Direver F.w version is1.04

r0127 parameter is "0" in the driver. is this important ? controlling card type is analog ?

Hi Alunare,

The part no. u have mentioned is an analog variant which does not have uss variant...

here you can only use analog command u can not use uss command for varying the speed.

u need an drive with uss variant.

pls find the brochure with part numbers

G110 BROCHURE