Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

CH_AI and PIW

Created by: Alberto_SPAIN at: 2/9/2010 6:20 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

2/9/2010 6:20 PM	Rate (0)
Alberto_SPAIN Posts: 6 Rating: (0)	Dear Sirs, another problem. I use to work with IW and CH_AI modules. I noticed a problem with the adquisition modules, they provide me the signals in PIW format in the HW config, not in IW format. So that, CH_AI doesn't work (shows me "Share address 254:61055 - The address entered is not permitted here") and I can't work as usually. The analog input cards are 6ES7 331-1KF01-0AB0. Is there any way of adapting this input addresses so they're compatible with CH_AI blocks. Best regards
Alberto_SPAIN Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

2/10/2010 12:50 AM	Rate (0)
Sydney Gold Member Joined: 1/4/2008 Last visit: 1/4/2025 Posts: 703 Rating: (96)	Hello, you canchange the addresses of these inputs in HW config according to process image range or increase this range in the CPU properties (Cycle/Clock Memory tab) to cover already defined addresses. Regards Sydney

Suggestion To thank Quote Answer

2/10/2010 11:01 AM	Rate (0)
Alberto_SPAIN Posts: 6 Rating: (0)	Hello Sydney, I just did that after writing the message and matches with your answer, It just works! thanks so much Best regards
Alberto_SPAIN Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on