Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Change Position Set Point while traversing

Created by: nandgate at: 9/2/2017 11:55 AM (2 Replies)

Rating (0)

Thanks 2

3 Entries

9/2/2017 11:55 AM	Rate (0)
nandgate Posts: 319 Rating: (9)	Hello All, I am controlling an Induction motor in Position Control Mode using CU250S-2PN. Is it possible to change the position set point of the CU while the Motor is moving towards its destination ? Thanks in advance, Regards, nandgate.
nandgate Posts: 319 Rating: (9)
Suggestion To thank Quote Answer

9/2/2017 9:55 PM	Rate (0)
@KB@ Silver Member Joined: 7/30/2012 Last visit: 12/2/2023 Posts: 335 Rating: (12)	Hello!!! Yes Its Possible... Check This Catalog...I Think You Have To Use On The Fly (Setpoint Change During Travese) http://ued.co.uk/userfiles/downloads/Siemens_Catalogues/Siemens_Sinamics_Shortform_Cat_Price_List_2013.pdf

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users nandgate

5/3/2019 12:03 PM	Rate (0)
nandgate Posts: 319 Rating: (9)	I have implemented it. Thanks for the Suggestion. regards, Nandgate.
nandgate Posts: 319 Rating: (9)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Jen_Moderator

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_G

Follow us on