Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Channel scale

Created by: Eli_47 at: 11/14/2012 7:34 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

11/14/2012 7:34 AM	Rate (0)
Eli_47 Experienced Member Joined: 8/23/2012 Last visit: 11/18/2024 Posts: 118 Rating: (4)	Good day. How i can do setting scale for chain channel driver- monitor analog with internal PCS7 method? (for example - set sensor scale from MonAnS faceplate). Regards, Eli

Suggestion To thank Quote Answer

11/14/2012 11:11 AM	Rate (0)
Silent Bob Posts: 836 Rating: (100)	You could answer the most of you questions by simple looking into manuals... http://support.automation.siemens.com/WW/view/en/61189432 http://support.automation.siemens.com/WW/view/en/61189457 http://support.automation.siemens.com/WW/view/en/61189618 http://support.automation.siemens.com/WW/view/en/61187410 http://support.automation.siemens.com/WW/view/en/57265833 http://support.automation.siemens.com/WW/view/en/57265842
Silent Bob Posts: 836 Rating: (100)
Suggestion To thank Quote Answer

11/15/2012 5:23 AM	Rate (0)
Eli_47 Experienced Member Joined: 8/23/2012 Last visit: 11/18/2024 Posts: 118 Rating: (4)	Silent Bob You could answer the most of you questions by simple looking into manuals... http://support.automation.siemens.com/WW/view/en/61189432 http://support.automation.siemens.com/WW/view/en/61189457 http://support.automation.siemens.com/WW/view/en/61189618 http://support.automation.siemens.com/WW/view/en/61187410 http://support.automation.siemens.com/WW/view/en/57265833 http://support.automation.siemens.com/WW/view/en/57265842 Thanks Bob. But here no solution how i can set channel driver (PCS7AnIn) scale via OS.

Suggestion To thank Quote Answer

11/19/2012 10:25 AM	Rate (0)
Silent Bob Posts: 836 Rating: (100)	Hi, if you can't change the Schale from OS you have to find another solution. Look in the APL Lib. There are blocks called like "OP_I" or so. With this blocks you have a Faceplate in WinCC where you can put int values (or real, or bool, depending on the block). Now you could connect the output of those blocks to the scale value of you channel, or measuring block. But pay attention to the alarm limits, when you change the scaling of the value during operation.
Silent Bob Posts: 836 Rating: (100)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on