Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

clock memory bits-not work

Created by: luciferC4 at: 3/25/2011 11:53 AM (6 Replies)

Rating (1)

Thanks 4

7 Entries

3/25/2011 11:53 AM	Rate (0)
luciferC4 Bronze Member Joined: 1/25/2006 Last visit: 10/9/2022 Posts: 257 Rating: (59)	Hi, I want to use clock memory bit in my program. In device configuration (CPU1212C) I assign MB0 as clock memory byte. I want to use m0.5 memory bit with frequncy 1Hz for an increment instruction. But,that not work. In monitoring I can't see activate state of M0.5 and, of course inc instruction isn't performed. Can someone tell me what's wrong? BR.

Suggestion To thank Quote Answer

3/25/2011 1:05 PM	Rate (0)
joisramesh Posts: 40 Rating: (1)	Hello, Its working just check once again in the "Device View" of the "Device Configuration" in your project. If not send your configuration so that I can have a look. BR
joisramesh Posts: 40 Rating: (1)
Suggestion To thank Quote Answer

3/25/2011 1:55 PM	Rate (0)
luciferC4 Bronze Member Joined: 1/25/2006 Last visit: 10/9/2022 Posts: 257 Rating: (59)	Hello,you'll see that I check clock memory bity. Should I do something else? BR Attachment screen1.zip (1045 Downloads)

Suggestion To thank Quote Answer

3/25/2011 2:25 PM	Rate (0)
Gorp Posts: 89 Rating: (16)	Clock memory bits and the used byte will now show in PLC tags unless you assign them yourself. Whenassigning memory bits, STEP7-Basic will make suggestions for the address to be used. If you did not assign the clock bits/byte yourself, the suggestion will start with M0.0 and so on. Make shure that you donotset M0.5 or MB0elsewhere in your program.
Gorp Posts: 89 Rating: (16)
Suggestion To thank Quote Answer

3/25/2011 8:06 PM	Rate (1)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 2/2/2023 Posts: 4177 Rating: (1324)	TIP: complie all and download all before test
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer
This contribution was helpful to 4 thankful Users Vasily.Gurin Marmiklan Joel AutoGen_3882380

3/28/2011 1:54 PM	Rate (0)
luciferC4 Bronze Member Joined: 1/25/2006 Last visit: 10/9/2022 Posts: 257 Rating: (59)	thanks Pegaia. Now program work properly. I compile all project and that download to PLC. All five PAC3200s and S7 1200 communicate now andI can see all neccessary data for this apllication. BR

Suggestion To thank Quote Answer

3/29/2011 12:47 PM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 2/2/2023 Posts: 4177 Rating: (1324)	Hi, I'm happy that you won :)
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on