Commissioning with STARTER or Startdrive

Dear sir/madam,

I'm tried to download SINAMICS Startdrive V13 SP1 on my PC however after downloading I could not find the program on my PC.

I'm not sure if this is a "stand alone" program or extension on TIA portal. I think it should be a stand alone program because the program in the SINAMICS G120 CU250S-2 Control Units manual the pictures look like a stand alone program.

Please could you explain step by step how to download SINAMICS V13 SP1.

With kind reguards,

Roy

Student ROC Van Twente

ChristophD

Hello,

no Startdrive is only StandAlone if no TIA is installed.

If a TIA Portal is installed the Startdrive is integrated in the Portal installation.

So start the TIA Portal and then in the HW Catalog in the Path Drives you find the Startdrive Devices.

Have you run the setup after the download?

Regards

Christoph

 I have on another machine Step 7 v5,5 and Startdrive V14 installed as standalone. What's the problem?

Msorich

New question published by AutoGen_889198 is split to a separate thread with the subject Open one backup in TIA V13 Sp1 but showing sinamics startdrive v12sp1& sinamics startdrive v13 software error.

Best regards
Jen_Moderator