Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Commssining cu 320 with s120

Created by: Zyad at: 3/22/2018 3:16 PM (2 Replies)

Rating (0)

Thanks 1

3 Entries

3/22/2018 3:16 PM	Rate (0)
Zyad Posts: 33 Rating: (0)	Dear expert I am required to add anew system in oure factory cu320 with 2 Motor module s120 1 Motor servo and other induction motor Can you explain what's steps to make a program in startar And make start up for thise program in cu
Zyad Posts: 33 Rating: (0)
Suggestion To thank

3/22/2018 3:26 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 1/27/2023 Posts: 21197 Rating: (2797)	please don't open new threads or occupy other threads with always the same topics. Why dont ask in you other Thread? https://support.industry.siemens.com/tf/ww/en/posts/cu320/187991/?page=0&pageSize=10

Suggestion To thank
This contribution was helpful to 1 thankful Users ixo65

3/23/2018 7:03 AM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 1/27/2023 Posts: 6416 Rating: (125)	Closed cause question posted twice. The second thread with the subject Cu320 is published within the conference SINAMICS. Best regards Jen_Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Jen_Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on