Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Communication between ControlLogix and S7300

Created by: canpol at: 6/17/2008 5:56 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

6/17/2008 5:56 PM	Rate (0)
canpol Posts: 3 Rating: (0)	Hi Everyone, I'm new to the forum. I have a project where I need to send messages between ControlLogix PLC (1756-L63) and S7300 (CPU 315-2 PN/DP). How I go about it? Thanks
canpol Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

6/17/2008 11:30 PM	Rate (0)
J_Bell Posts: 5822 Rating: (412)	Hello, may you think about this solution? Communication between SIMATIC S7 and Allen-Bradley ControlLogix CPUs via Ethernet: Use of "Echochange" gateways I hope it will fit your requirements. Best regards J_Bell
J_Bell Posts: 5822 Rating: (412)
Suggestion To thank Quote Answer

6/18/2008 10:40 AM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 1/22/2025 Posts: 12330 Rating: (2702)	Hello canrol; Another option would be to setup a Profibus-DP interface in the Controllogix rack (a SST_CLX_PFB_RLL from Woodhead or a MVI56-PDPMV1 from Prosoft technologies) and use a Master/slave exchange with the S7 integratedDP interface. If you can live with 244 bytes IN and 244 bytes OUT per exchange, that would be a very quick and exsy way to go. Hope this helps, Daniel Chartier

Suggestion To thank Quote Answer

6/23/2008 2:55 PM	Rate (0)
JMJ Posts: 487 Rating: (45)	IF you are good at ethernet communication It should also be possible to use TCP/IP or UDP socket communication over ethernet. On siemens side evenCP343-1 Lean supports this but on AB code you need E-WEB module. Sorry, I do not have a sample program.
JMJ Posts: 487 Rating: (45)
Suggestion To thank Quote Answer

9/17/2008 8:03 AM	Rate (0)
Paresh Posts: 116 Rating: (1)	another solution will be Gateway 00 from Renu Electronics.
Paresh Posts: 116 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on