Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Communication problem with PLC simulator

Created by: Spiz at: 4/23/2014 5:33 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

4/23/2014 5:33 PM	Rate (0)
Spiz Posts: 13 Rating: (0)	Hi everybody I can not download blocks to CPU in simulator. I get the message "unable to reach the module CPU xxx by means of the subnet assigned to the programming device/PC" no matter what PG interface I set. Mind you that the CPU is detected ok from accessible nodes. pc OS win-7 64 bit proffesional STEP7 PROF 2010 SR3 Any help would be appreciated Thanks
Spiz Posts: 13 Rating: (0)	Last edited by: Spiz at: 4/23/2014 6:30 PM
Suggestion To thank Quote Answer

4/30/2014 2:35 PM	Rate (0)
Cicero Gold Member Joined: 10/10/2005 Last visit: 1/22/2025 Posts: 1929 Rating: (136)	Hello, see the FAQ in this regards and check the interface adjustments. http://support.automation.siemens.com/WW/view/en/42637263 With best regards Cicero

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on