Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Config CP341

Created by: Licon at: 1/22/2009 1:17 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

1/22/2009 1:17 PM	Rate (0)
Licon Posts: 5 Rating: (0)	Hi, Only one question, in the parameters of cp341 in tab Fc03. I have MODBUS-Address from 0, Commence al DB 21. if my mastes(DCS), read 40001 onwards, means that 40001 will go to the 0 position and there to the DB21.x THANKS!
Licon Posts: 5 Rating: (0)	Last edited by: Licon at: 1/22/2009 1:20 PM
Suggestion To thank Quote Answer

1/22/2009 2:53 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 2/14/2025 Posts: 8848 Rating: (1181)	Dear Licon, Perhaps this manual might help: http://support.automation.siemens.com/WW/view/en/1218007 See par 4.6 and chapter 8 Best regards, Wizard

Suggestion To thank Quote Answer

1/26/2009 11:18 AM	Rate (0)
Licon Posts: 5 Rating: (0)	thanks Wizard, ok. I have already seen, but how can I know the address that corresponds to modbus db21.dbw66 for example.
Licon Posts: 5 Rating: (0)	Last edited by: Licon at: 1/26/2009 11:20 AM
Suggestion To thank Quote Answer

1/26/2009 4:42 PM	Rate (0)
Licon Posts: 5 Rating: (0)	...I think that corresponds to 40,066 of MODBUS for example, it's ok?
Licon Posts: 5 Rating: (0)	Last edited by: Licon at: 1/26/2009 4:42 PM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on