Configureing actuators in STEP7

I have Intelli+ Bernard actuators, and i need to configure it correctly.

For controlling the whole process i use the SIMATIC S7-300 controller. I have some difficulties with configuring the hardware, when i put the Intelli+ modules into free space. When I put AI (32-byte) module into 1-st place, i can see some numbers there, when i monitor it. But when i put it into the second or 3-d place, i can see some different numbers in the same channels. At the same time, when i put the DI module into the first place, i can see some indication (green leds), but when i put it on another place, i can't see anything. May be you have some experience and know, how to configure it?

The task is: 1. to get information from this actuator as much as possible (errors, position in %, system data,...) because it has these possibilities.
2. control it remotely by editing the % in operating station. (actually i can do it: when the AI (32-byte) module is in the 1-st place, i can read from the last channel and make some operations with the numbers i can get, because it's from 0 to 1000. So it's very easy to transfer into 0...100% scale.)

I would be very thankful, if you give me some information about, how to do it correctly.

The file attached bellow...
i'll send the source too after few minutes

Hi

I have look at your project, and properly figured what your problem is. The information you get form slot is contain the information of the position, and properly some status bit. The I/O is properly some bits where you can get access to information and basic controlling.

I been on the internet to see if I could find some description on your node, but I did not find anything.

You have to read the manual for vale and pay attention to part where the interface to profibus is describe, if you have some difficulty upload the manual and I will try to help you.