Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

connect CP5431 to ET200U

Created by: NICHOL at: 11/28/2008 10:34 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

11/28/2008 10:34 AM	Rate (0)
NICHOL Posts: 4 Rating: (0)	Dear all: I want to know how to connect CP5431 to ET200U with DP protocol. another question is: can CP5431 connect to ET200M with DP protocol? the CP5431 part number is:6GK1543-1AA01; the interface of ET200U is:6ES5318-8MB12. thanks a lot!
NICHOL Posts: 4 Rating: (0)	Last edited by: NICHOL at: 11/29/2008 5:21 PM
Suggestion To thank Quote Answer

12/2/2008 9:36 PM	Rate (0)
jklm Platinum Member Joined: 12/22/2006 Last visit: 1/25/2022 Posts: 1742 Rating: (308)	Hello, Look into this manual http://support.automation.siemens.com/WW/view/en/1804226 Chapter 11
	Best regards jklm Suggestion was helpful? Feel free to rate it.
Suggestion To thank Quote Answer

12/3/2008 4:04 AM	Rate (0)
NICHOL Posts: 4 Rating: (0)	thanks foryour information. i will try it.
NICHOL Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

12/8/2008 4:34 AM	Rate (0)
NICHOL Posts: 4 Rating: (0)	Dear all: I have read the document and I have known the procedure of configuration,but I don't know how to program. Do you know how to use the synchronize HDB and the send/receive HDB? How to configure the parameter of the blocks and what is block number in S5-135U PLC? Thanksin advance!
NICHOL Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on