Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Connect Sinumerik 802D Sl with starter

Created by: Josef Drapela at: 5/26/2009 8:09 AM (5 Replies)

Rating (0)

Thanks 0

6 Entries

5/26/2009 8:09 AM	Rate (0)
Josef Drapela Experienced Member Joined: 3/30/2009 Last visit: 1/8/2025 Posts: 11 Rating: (0)	Dear all I cant connect to Sinamics - 802d sl with starter. Starter find connect point, but doesnt know. Thank you.

Suggestion To thank Quote Answer

5/26/2009 9:38 AM	Rate (0)
RAM81 Silver Member Joined: 3/3/2008 Last visit: 10/5/2023 Posts: 333 Rating: (52)	hi what is the protocol you are using for communication? are you trying via RS232 or TCP/IP. if you are trying via rs232 then make connect on in step7 status page and in starter in set pg/pc interface select serial cable PPI as priotocol. if you use TCP/IP then try to match the IP address and in service displaygo to service controlmake direct connection on

Suggestion To thank Quote Answer

5/26/2009 9:59 AM	Rate (0)
Josef Drapela Experienced Member Joined: 3/30/2009 Last visit: 1/8/2025 Posts: 11 Rating: (0)	Hi I use TCP/IP. IP adres are correct, because ping is OK. Starter found connect point, but doesnt know type.....and cannot with connect and upload project.. thanks

Suggestion To thank Quote Answer

5/26/2009 10:09 AM	Rate (0)
RAM81 Silver Member Joined: 3/3/2008 Last visit: 10/5/2023 Posts: 333 Rating: (52)	hi just create a new project and do the settings as per the picture. here i assumed that you are using direct connection. Attachment starter.JPG (493 Downloads)

Suggestion To thank Quote Answer

5/26/2009 11:57 AM	Rate (0)
Josef Drapela Experienced Member Joined: 3/30/2009 Last visit: 1/8/2025 Posts: 11 Rating: (0)	Hi I thank you for your advice. Already Iam made upload project. But I wanted control zero mark with p0496 and r0497. This parametr I cant find. Acces level is Expert. Thank you

Suggestion To thank Quote Answer

10/9/2022 7:29 PM	Rate (0)
Tiago85 Joined: 10/9/2022 Last visit: 10/9/2022 Posts: 1 Rating: (0)	whats version is this starter software? because here dont show sinamics in 802d

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on