copy from PLC S7-300

hello .

I have  CPU313C "313-5BE00-0AB0" plc, and I want to copy its program to another plc but the second one is PLC CPU313C "313-5BG04-0AB0". does it make any conflicts? or I can use the program on the second one freely

and how can i copy the flash memory to the second ?

thanks

Verify that your hardware configuration has been set up correctly (I/O-addresses, network configuration...).

So you need to change type of cpu in hw config that's for sure...

Hello,

• What should you watch out for when changing from one S7-300 CPU to another?

Successor Successor Successor....

6ES7313-5BG04-0AB0

• The new product can replace the old one when modifing the hardware configuration and may be you need to modify something in the code / program itself.

And for this use S7-300 Upgrade Check tool.

• S7-300 Upgrade Check Tool
•   Put the MMC in the slot of the CPU, then use Step 7 to download the program to the CPU and MMC.
• Kindly find the attached file.

MacS7

Verify that your hardware configuration has been set up correctly (I/O-addresses, network configuration...).

So you need to change type of cpu in hw config that's for sure...

thanks mr. Mac S7

 its ok . the cpu work well .

but i must put the old  memory card to run ok . if i put the new memory the machine not work !

how can i make copy from old memory card to new one ?

Online Tech

Hello,

• What should you watch out for when changing from one S7-300 CPU to another?

6ES7313-5BE00-0AB0

Successor Successor Successor....

6ES7313-5BG04-0AB0

• The new product can replace the old one when modifing the hardware configuration and may be you need to modify something in the code / program itself.

And for this use S7-300 Upgrade Check tool.

• S7-300 Upgrade Check Tool
•   Put the MMC in the slot of the CPU, then use Step 7 to download the program to the CPU and MMC.
• Kindly find the attached file.

 

 Dear Eng.Mohammad thanks very much :)

if you can match your new PLC in HW configuration and be ensure new oone want to support allof capability of the last one you can do it

but i think if it conclude newer version PLC u can do it , and i suggest read all of two PLC's documentation carfully and compare charactestics.