Counting Problem in AI module

hello,

one problem occurs during site ,

IN analog module full counts getting for 8mA current signal from the field side ,i hv get +32676 count in AI channel.

y full count is getting?

module number is 6ES7-134-4MB02-0AB0.

please give proper solution for this.

thnk u,

Hello Ashish,

the module is only for current messurement with 2-wire transducer as you can see in the technical Data:

https://support.industry.siemens.com/cs/pd/100636?pdti=1&lc=en-EN

what kind of transducer do you have and what kind of messurement have you selected in your HW-Config?

dear sir,

Reading not change if mA change count is stable as always.

siR,

In field side we have connected potentiometer 4 -20 mA output.

and in hardware configuration we have selected current 4-20 mA. 

please open attached snap for hardware confi.

You certainly have wrong connection on your module.

You selected 4-20mA and you connected a potentiometer. (This is wrong)

You need to connect the field correctly to your module (see attachment)

dea sir,

but from the field side potentiometer gives 4-20 mA output properly .

my question is y the full count is getting??

problem is where from field side ya AI module side??

and how to resolved it???

You mean that you have a transmitter after the potentiometer that converts the resistance to 4-20mA?

Getting the full range all the time could mean a short circuit. If you have a milliampere injector then try to inject current to the analog input channel after disconnecting the field and notice the value while changing the input.