SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

CP 343-1 AG_Send and AG_ Recv error 8183

11/4/2017 5:25 PM	Rate (0)
garu3d Posts: 51 Rating: (0)	i try to exchange data between 2 plc s7-300 with cp 343-1 . i get error code 8183 when the send command is trigged by OB35 . CPU and CP 343-1 is stiil work without any error led . Attachment S7_Pro2.zip (164 Downloads)
garu3d Posts: 51 Rating: (0)
Suggestion To thank Quote Answer

11/4/2017 5:34 PM	Rate (0)
Duris_I Diamond Expert Joined: 4/28/2015 Last visit: 2/24/2025 Posts: 10832 Rating: (836)	Hello, look to attachment. Attachment AG_SEND_err.jpg (770 Downloads)
	With best regards... Ivan Duris Flight: OMICO
Suggestion To thank Quote Answer

11/4/2017 6:10 PM	Rate (0)
garu3d Posts: 51 Rating: (0)	thanks , but i already active TCP connection . Attachment netpro.png (642 Downloads)
garu3d Posts: 51 Rating: (0)
Suggestion To thank Quote Answer

11/5/2017 9:37 AM	Rate (0)
Duris_I Diamond Expert Joined: 4/28/2015 Last visit: 2/24/2025 Posts: 10832 Rating: (836)	Hello, try for now omit OB35 and make test via FC/FB in standard cycle time. Prepare that REQ bit as memory and reset it via condition after successful check of DONE/ERR bit. Check STATUS value via condition and save it to other memory f.ex.
	With best regards... Ivan Duris Flight: OMICO
Suggestion To thank Quote Answer

11/7/2017 9:45 AM	Rate (0)
Kaulquappe Posts: 3093 Rating: (324)	Hello, I would check the status of the connection in the special diagnosis of the CP. There you can get the current status and you can recognize whether the connection was established and then terminiated or if it wasn't established all the time. You can also take a look at diagnostic buffer of the CP. Check the port numbers you are using. Regards, Kaulquappe
Kaulquappe Posts: 3093 Rating: (324)
Suggestion To thank Quote Answer

Share this page:

Share this page on...