Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

CP 343-1 V1.3

Created by: Omarissimo at: 5/24/2010 11:01 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

5/24/2010 11:01 AM	Rate (0)
Omarissimo Posts: 4 Rating: (0)	Hi all. I have a CP 343-1 6GK7 343-1EX21-0XE0 firmware version 1.3. How to add it to a S7 project, since in the HW catalog i have only V1.2 version? I've tried HW update but no results... Thank you for help! Omar Roba Senior SW Engineer B&B Automation
Omarissimo Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

5/24/2010 12:23 PM	Rate (0)
umencho Diamond Expert Joined: 3/21/2006 Last visit: 1/14/2025 Posts: 10239 Rating: (1182)	Hello Omar Roba, Did you try with update of hardware catalog. Look at How can you update the hardware catalog without direct Internet access? Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

5/24/2010 2:02 PM	Rate (0)
Omarissimo Posts: 4 Rating: (0)	Hi Hristo, I've already tried but without success:the HW catalog update tool offers the 1.2 version of that card. My S7 version is 5.4 + SP5, which seems to be the most up to date. Other suggestions? Thank you! Omar Roba B&B Automation
Omarissimo Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

5/25/2010 3:33 PM	Rate (0)
little holmes Experienced Member Joined: 12/9/2009 Last visit: 4/18/2024 Posts: 156 Rating: (11)	Hello, There isn`t a separate entry for each firmware version in the hardware cataloge. Only in case of configurable changes. You can configure the CP343-1 EX21 with V1.2 in the hardware configuration, also when V1.3 is downloaded. All functions of firmware V1.3 should be available. Best regards Little Holmes

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on