Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

CU320 2PN Maintenance required

Created by: nonocos at: 5/9/2019 8:32 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

5/9/2019 8:32 AM	Rate (0)
nonocos Advanced Member Joined: 6/13/2018 Last visit: 1/24/2023 Posts: 32 Rating: (1)	Hello, Working with S7 V5.5, into the HW-Config I have a CU320 2PN (6SL3040-1MA01-0AA0). When I go online, I have some elements like the Control Unit or one axis, where there is a green wrench logo over it. Diagnostic says : Maintenance required Error 36881 / 36872 / 36873 / 36680. What does it means ? I did not found any documentation regarding this. Despite this, the CU works fine. Best Regards
	Last edited by: nonocos at: 05/09/2019 08:32:55
Suggestion To thank Quote Answer

5/9/2019 8:42 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 1/27/2023 Posts: 21197 Rating: (2797)	Hello, do you have some screens for this? Regards Christoph

Suggestion To thank Quote Answer

5/9/2019 9:02 AM	Rate (0)
nonocos Advanced Member Joined: 6/13/2018 Last visit: 1/24/2023 Posts: 32 Rating: (1)	Herewith Attachment Unbenannt.JPG (43 Downloads)

Suggestion To thank Quote Answer

5/9/2019 10:43 AM	Rate (0)
RB91 Gold Member Joined: 4/28/2015 Last visit: 9/20/2022 Posts: 1278 Rating: (283)	Hello, I would recommend to open the drive in the commissioning tool Starter, go online with it and check the faults and warnings on the drive.
	Best regards, Robert
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on