Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

cu320 changing Standard telegram 1 PZD2/2 parameter p0840 BI:ON/OFF

Created by: ziro_sub at: 7/29/2011 6:47 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

7/29/2011 6:47 PM	Rate (0)
ziro_sub Posts: 11 Rating: (0)	ok , thanks very much, yet wanted to also ask about something, got the telegram lets say Standard telegram 1 PZD2/2 - I have tried to change for example parameter p0840 BI:ON/OFF (the one I think responsible directlly for start the motor) to be connected to CU320 x122 DI 0 but it isn`t possible, so I changed to free BICO telegram, from StandarD telegram, now I can but IS THERE ANY OTHER OPTION to change and use DI or only FREE CONFIGURABLE BICO telegram and is there anything else i need to set for this communication method???? Kamil
ziro_sub Posts: 11 Rating: (0)	Last edited by: CS Moderator at: 7/31/2011 9:41 AM new subject after splitting
Suggestion To thank Quote Answer

7/30/2011 6:52 PM	Rate (0)
DenisMor Posts: 344 Rating: (50)	Standard PROFIDrive telegrams configure the drive to communicate over the network in a standard way, so the system locks out any modifications. If changes are needed from the standard telegram you have to switch to Free BICO.
DenisMor Posts: 344 Rating: (50)
Suggestion To thank Quote Answer

8/3/2011 5:59 PM	Rate (0)
ziro_sub Posts: 11 Rating: (0)	ok, thanks. I`d changed the standard telegram to Bico, so all the previus assigned bits are still the same, and I can modify them as i want. Thanks.
ziro_sub Posts: 11 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on