Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Current Trailling Weight

Created by: AutoGen_6958441 at: 2/23/2024 5:52 AM (4 Replies)

Rating (0)

Thanks 1

5 Entries

2/23/2024 5:52 AM	Rate (0)
AutoGen_6958441 Member Joined: 3/30/2020 Last visit: 10/26/2024 Posts: 28 Rating: (0)	HI, I am using WP251 with S7 1200 CPU 1215C DC/DC/DC and found out DR 31 has Current Trailing Weight to read the trailing weight after dosing Finished but i keep getting same values of 100g. I already insert values In DR 23 Trailing Weight Fine and Coarse. Is there any settings to on the trailing weight to show trailing weight after dosing Finished. Thanks, Baldeep
	Last edited by: AutoGen_6958441 at: 02/23/2024 07:15:19
Suggestion To thank Quote Answer

2/23/2024 8:24 AM	Rate (0)
Siwarexi Gold Expert Joined: 1/4/2007 Last visit: 12/5/2024 Posts: 1153 Rating: (175)	Hello Baldeep, If you would like to see an updated trailing weight in DR31, you have to switch on the proportional controller in DR24 AND you have to set the parameters for the proportional controller correctly in DR24! Do you have the Siwatool-software? If so, you can send to me a Siwatool-file with the current parameter-settings of your WP251. Then I can help you in much better way. Best regards Siwarexi

Suggestion To thank Quote Answer

2/27/2024 7:35 AM	Rate (0)
AutoGen_6958441 Member Joined: 3/30/2020 Last visit: 10/26/2024 Posts: 28 Rating: (0)	This is my parameter using Siwatool Attachment Siwatool_File_1.zip (372 Downloads)

Suggestion To thank Quote Answer

2/27/2024 10:53 AM	Rate (0)
Siwarexi Gold Expert Joined: 1/4/2007 Last visit: 12/5/2024 Posts: 1153 Rating: (175)	Hello Baldeep, The WP251 is working proper 😊. Take a look to the attached file, please: Your specification in DR23 for the trailing weight is set to “0.2”, and the proportional controller is on in DR24 (that's ok). As you can see in DR31, the trailing weight changed from 0.2 to 0.1813688. That means, the proportional controller is working 😊. One hint for you: The “Max. control access of proportional controller” in DR24 is set to 5%, and this is a little bit high! Your setpoint is 10 kg, and you allow the proportional controller to change the trailing weight for the next dosing of 5%, that’s: 0.5 kg. That’s a little bit high! Maybe 1% is better. Best regards Siwarexi Attachment trailing weight.png (327 Downloads)

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users AutoGen_6958441

2/27/2024 2:28 PM	Rate (0)
AutoGen_6958441 Member Joined: 3/30/2020 Last visit: 10/26/2024 Posts: 28 Rating: (0)	Ok thx

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on