Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Cursor key on TD

Created by: Plesa at: 2/5/2011 7:05 PM (3 Replies)

Rating (0)

Thanks 2

4 Entries

2/5/2011 7:05 PM	Rate (0)
Plesa Posts: 4 Rating: (0)	Can I use the cursor key on TD to start the relay coil. I tried in the simulation, and everything works, but in reality does not work. Thanks in advance.
Plesa Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

2/7/2011 9:18 AM	Rate (0)
Helmut_13 Posts: 2930 Rating: (432)	Hi, if you read the maunal, then you can find that you have to press ESC & Curso key at the same time. In simulation you just click it. Regards
Helmut_13 Posts: 2930 Rating: (432)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users Andres [Str] ScottBengtson

2/7/2011 10:38 AM	Rate (0)
Andres [Str] Posts: 153 Rating: (17)	Hi_Hlapic In the program it is necessary to enter following parameters for cursors (Momentary pushbutton (make)) that cursors worked really. Also LOGO!SOFT has function ONLINE TEST where it is possible to look as the program works. Attachment Cursor Key.JPG (755 Downloads)
Andres [Str] Posts: 153 Rating: (17)	Last edited by: Andres [Str] at: 2/7/2011 10:40 AM
Suggestion To thank Quote Answer

2/7/2011 11:13 AM	Rate (0)
Plesa Posts: 4 Rating: (0)	Of course I did not read the instructions. I just tried, and works. Thank you both.
Plesa Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on