Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Cycle95 and 952

Created by: Elorri at: 12/12/2011 11:35 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

12/12/2011 11:35 PM	Rate (0)
Elorri Posts: 13 Rating: (0)	Hello again, I wonder if it's possible to program cycle 95 in the new versions of Sinumerik 840D, I can't find in the menu. And about cycle 952 (contour grooving), I read once and again about the reason of writting 3 file names it asks (PR, CON and CONR), but i don't understand what they are for. Thanks again
Elorri Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

12/15/2011 12:53 PM	Rate (0)
vki Posts: 63 Rating: (3)	system is 840d or 840dsl?
vki Posts: 63 Rating: (3)
Suggestion To thank Quote Answer

12/18/2011 3:28 PM	Rate (0)
Elorri Posts: 13 Rating: (0)	Hi vki, it's 840Dsl
Elorri Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

12/20/2011 1:55 PM	Rate (0)
Syed_bdvt Posts: 11 Rating: (4)	Hello elorri, PRG means Name of the file which will be saved after execution of cycle952. We can say that output of cycle952. There is no connection with contour. you can give any name. CON means Name of updated file for residual material machining (whichis mentioned inGrooving cylce952, not in residual material machining), This is referencefile for control to calculate how much material is available for residual material machining. CONR means after one residual maching again if want do one more residual machining again mention the file name. For any programing support let me know Best regards Syed imityaz
Syed_bdvt Posts: 11 Rating: (4)
Suggestion To thank Quote Answer

12/20/2011 2:31 PM	Rate (0)
Elorri Posts: 13 Rating: (0)	Understood! Thanks a lot Syed Imityaz
Elorri Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on