Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Cycle952 with unmachined-part contour

Created by: Elorri at: 12/18/2011 5:30 PM (3 Replies)

Rating (2)

Thanks 2

4 Entries

12/18/2011 5:30 PM	Rate (0)
Elorri Posts: 13 Rating: (0)	Stock removal (CYCLE952): For stock removal, the cycle takes into account a blank that can comprise a cylinder, an allowance on the finished-part contour or any unmachined-part contour. You must define an unmachined-part contour as a separate closed contour in advance of the finished-part contour. In case of unmachined-part contour, could somebody confirm if is this the correct program structure (It doesn't work in my pc)? N9 CYCLE62(,2,"E_LAB_A_CONT_2","E_LAB_E_CONT_2") N10 CYCLE952 (BL=CONTOUR) M30 E_LAB_A_CONT_1: .....unmachined-part contour definition E_LAB_E_CONT_1: E_LAB_A_CONT_2: .....final contour definition E_LAB_E_CONT_2:
Elorri Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

12/20/2011 1:00 PM	Rate (2)
Syed_bdvt Posts: 11 Rating: (4)	Hello elorri, Please find the attachment which includes example of unmachined contour with cycle952. For any further support let me know. Best regards Syed imtiyaz Attachment Unmachined_contour.pdf (222 Downloads)
Syed_bdvt Posts: 11 Rating: (4)	Last edited by: Syed_bdvt at: 12/20/2011 1:05 PM New attachement is attached for reference
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users Ekalavya Elorri

12/20/2011 9:01 PM	Rate (0)
Elorri Posts: 13 Rating: (0)	Yes man, it works!! The example of the Siemens handbook had a mistake Thank you very much
Elorri Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

12/26/2011 1:36 PM	Rate (0)
Syed_bdvt Posts: 11 Rating: (4)	Thanks elorri
Syed_bdvt Posts: 11 Rating: (4)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on