Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Danfoss Drive control from S7 1200

Created by: GaJEnDrA D S at: 11/1/2022 12:01 PM (2 Replies)

Rating (0)

Thanks 1

3 Entries

11/1/2022 12:01 PM	Rate (0)
GaJEnDrA D S Bronze Member Joined: 8/9/2011 Last visit: 11/1/2023 Posts: 324 Rating: (19)	Dear All, I am using VLT Microdrive Danfoss. I need technical support for running this VFD from PLC S7 1200. 1) Terminals for Analog frequency command? 2) Parameters to enable switching between Jog/Remote Mode 3) above 2 points are enough ? Or I have to give Digital start command along with analog reference too? Pls help me with complete procedure to RUN this VFD from PLC.. I am only looking for knowing things about drive and its requirements. I know how to configure from PLC accordingly . Thanks Gajendra D S
	Last edited by: GaJEnDrA D S at: 11/02/2022 05:14:13 Last edited by: GaJEnDrA D S at: 11/02/2022 06:13:38 "Any intelligent fool can make things bigger, more complex. It takes a touch of genius -- and a lot of courage -- to move in the opposite direction.":):)
Suggestion To thank Quote Answer

11/2/2022 12:25 PM	Rate (0)
SCOTT123 Bronze Member Joined: 10/16/2007 Last visit: 1/13/2025 Posts: 637 Rating: (45)	Hello, you could download the manual for the wiring diagram. Normally you need one analogue signal in case you need to change the speed. It depends if you want to run the VLT in Jog mode. Then you need a start signal from the plc, normally a feed back (fault/running) from VLT to plc and maybe a reset signal from plc to VLT. Scott

Suggestion To thank Quote Answer

11/2/2022 12:28 PM	Rate (0)
jacek d Platinum Member Joined: 9/23/2005 Last visit: 1/17/2025 Posts: 4851 Rating: (741)	https://www.danfoss.com/en/contact-us/
	Regards, Jacek What is confusing you is the fact that you never see a number but always its digit representation. So you end up thinking that the number is the representation. - Andrej Bauer Any claims against me - based on whatever legal reason - resulting from the use of any code and/or ideas presented on this forum shall be excluded. #StayWithUkraine
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Hati

|

Share this page:

Share this page on...

Follow us on