Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

DB blocks dont show in S7 Program blocks folder in PCS7v7

Created by: Janko at: 3/20/2008 11:20 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

3/20/2008 11:20 AM	Rate (0)
Janko Advanced Member Joined: 7/17/2007 Last visit: 10/7/2024 Posts: 27 Rating: (0)	Hello Iwork on Simatic PCS7 v7. Problem: When i compile CFC chart in plant view, i see DB blocks of S7 program in blocks folder ( in component view ) .But when i click with mouse on charts folder or anything else and then back again on S7 program Blocks folder, i see only OB- s. If i insert VAT table, it is also not shown in blocks folder. But with command "PLC-> Display Force values", i can open it . I download the HW Configuration and S7 program to PLC (S7 -400). And in online mode in Simatic manager i can see all DB, FC,FB in blocks folder, which i can not see in the offline mode. I made the projectwith PCS7 Wizard. So what could be the problem that are shown only OB-s in S7 program blocks folder in Simatic manager? Thank you inadavance Best regards Janko

Suggestion To thank Quote Answer

3/27/2008 9:13 PM	Rate (0)
Sydney Gold Member Joined: 1/4/2008 Last visit: 9/26/2024 Posts: 703 Rating: (96)	Hello, isn't possible that you have mistakenfiltered view?

Suggestion To thank Quote Answer

3/27/2008 11:09 PM	Rate (0)
Janko Advanced Member Joined: 7/17/2007 Last visit: 10/7/2024 Posts: 27 Rating: (0)	Hello Yes. My filtered view was set just for OBs. I didnt noticed that is just that. Thank you Janko

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on