Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

did you have any sample ladder logic for step 7 on control the simocode, like start, stop and run feedback?

Created by: jker at: 10/24/2012 5:38 PM (4 Replies)

Rating (1)

Thanks 0

5 Entries

10/24/2012 5:38 PM	Rate (0)
jker Regular Member Joined: 5/17/2012 Last visit: 1/16/2025 Posts: 7 Rating: (0)	Dear wzrdstrm, did you have any sample ladder logic for step 7 on control the simocode, like start, stop and run feedback. thank you.
	Last edited by: O_Moderator at: 10/25/2012 10:12 AM new subject after splitting from /tf/WW/en/Posts/21926#top
Suggestion To thank Quote Answer

10/26/2012 11:04 AM	Rate (1)
LesPaul Posts: 467 Rating: (59)	hello, please see the screenshots below: - sample to stop the motor - additional Bit 0.5 is necessary for standard parameterization to change control mode to "Remote" - you find your output address at SIMOCODE-DP GSD device in HW Config. - At SIMOCODE DPparameterization(by GSD or Win-SIMOCODE-DP)you find the bit offset for your address -the standard parameterization of PLC output address assignment for operation: -the standard parameterization of PLC input address assignment (feedback coming from SIMOCODE device): So you need to know the parameterization of SIMOCODE-DP to use the right bits at your PLC program. Attachment Input_assignment_PLC_view.jpg (667 Downloads)
LesPaul Posts: 467 Rating: (59)	Last edited by: O_Moderator at: 10/26/2012 11:19 AM Last edited by: LesPaul at: 10/26/2012 11:05 AM see also the following attachments
Suggestion To thank Quote Answer

10/26/2012 11:10 AM	Rate (0)
LesPaul Posts: 467 Rating: (59)	2. Attachment Ladder_Logic_sample.jpg (866 Downloads)
LesPaul Posts: 467 Rating: (59)	Last edited by: O_Moderator at: 10/26/2012 11:18 AM
Suggestion To thank Quote Answer

10/26/2012 11:10 AM	Rate (0)
LesPaul Posts: 467 Rating: (59)	3. Attachment Output_assignment_PLC_view_for_control.jpg (656 Downloads)
LesPaul Posts: 467 Rating: (59)	Last edited by: O_Moderator at: 10/26/2012 11:20 AM
Suggestion To thank Quote Answer

10/26/2012 11:10 AM	Rate (0)
LesPaul Posts: 467 Rating: (59)	4. Attachment Output_assignment_PLC_view_for_control_mode.jpg (579 Downloads)
LesPaul Posts: 467 Rating: (59)	Last edited by: O_Moderator at: 10/26/2012 11:21 AM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on