Dear Sir,

Is it possible to define different IP series with two Ethernet port .  Like that 

1. 192.168.0.10

2. 172.27.186.104

My PLC network is 192 series , and 172 series is an another network. Is it possible to transfer the same data via another IP address. 

Regards,

Anirban

Hello,

See the attached screen shot of HMI specification. KP700 comfort having single Profinet interface with two PN port. Its acting as switch. So you can not provide two IP at same time.

Let see if you have two PLC , PLC A 192.168.0.1 and PLC B 172.16.0.1, while engineering create the single connection with either PLC A or PLCB. Use event "Change connection" to switch over connection from A to B or vice versa during run-time. After switching you need to change IP of HMI in control panel with same series of changed connection PLC IP. provided that both plc having same program backup only IP is different.

Respected Sir,

You can use a router for this Purpose. Please refer to scalance documentation.

KaushalKumarJoshi

Respected Sir,

You can use a router for this Purpose. Please refer to scalance documentation.

 Actually I want to do it with HMI . Don't to add another hardware . That's why I am asking. 

Murof

Hello rondip2000

With your Comfort Panel 700 its not possible here you have only one networkcard (the two interfaces are a little switch).

If you have a Comfort Panel 1500 or bigger then you have two Ethernet Cards and you could get your usecase work. (Here you have two ethernet ports 100mbit for Profinet Communication and a third one for GBit Ethernet communication)

Bye Murof

 Thank you very much for the information . I am going with SIMATIC HMI TP1500 COMFORT .