Navigation

doubt about measuring sockets in s120

Created by: mikellass at: 9/19/2016 10:19 AM (1 Replies)

9/19/2016 10:19 AM	Rate (0)
mikellass Posts: 115 Rating: (4)	hello, I've started working with measuring sockets in a S120 with CU 320 DP. Is there any posibility to get the encoder signal from this measuring sockets (T0,T1,T2)? I mean, sine, cosine and zero pulse. I read sinamics s120 manual but I didnt find any information...
mikellass Posts: 115 Rating: (4)
Suggestion To thank Quote Answer

9/19/2016 10:25 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 10/10/2024 Posts: 22409 Rating: (3017)	Hello, no this is not possible. Regards Christoph

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users mikellass