Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

DP slave error

Created by: venkyy at: 4/17/2014 7:55 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

4/17/2014 7:55 AM	Rate (0)
venkyy Posts: 27 Rating: (0)	Hello Dear friends.....! i would like ask you about related to DP slave........in H-configured network. i have redundant configuration , in that i have 4 CP's. in 3rd CP of rack 1, it was showing EXT F. i found " in hmi" one ET 200M module status bit giving alarm ( this ET 200m module connected through this CP ). And i also checked physically, that ET 200M module does not showing any LED indication of SF or BF . And i checked the bit , which causes an alarm indication in HMI . this bit coming from DB related to R_CP443_EXT_3 (Name of DB). Thnks & Rgrds VENKYY
venkyy Posts: 27 Rating: (0)
Suggestion To thank Quote Answer

5/2/2014 2:37 PM	Rate (0)
Sachinpatke Silver Member Joined: 12/9/2010 Last visit: 10/8/2022 Posts: 623 Rating: (77)	Dear Venkyy, Your explaination is not enough. If you have used 'Report system error' function in HMI, then do following. Recompile HW configuration and Regenate data for 'Report system error' and download data to PLC and refersh SCADA. If your problem does not get solved with this, reply with better description.
	If you like the comment, rate it (right top) or thank it (left bottom). One who says he can & one who says he can't, are both correct-Confusius. Automation- C2C, Management Sachin Patke, India.
Suggestion To thank Quote Answer

5/30/2014 9:24 PM	Rate (0)
SMHZ Bronze Member Joined: 10/19/2012 Last visit: 4/17/2022 Posts: 315 Rating: (9)	Did u chk y the DB is giving error?

Suggestion To thank Quote Answer

5/30/2014 9:32 PM	Rate (0)
SolutionFinder Posts: 559 Rating: (87)	What us that DB? What is the use for it?
SolutionFinder Posts: 559 Rating: (87)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on