Hi,Denilson Pegaia

Is it possible to enter a value in hmi for hsc in plc1200 when the power become off and on?Because when the power become off the counted value become zero and I want to enter value after power become on.

Thanks in advance

------------------------------------------------------------------------------------------
Split fromSample Program: S7-1200 High Speed Counter (HSC).

 Hello.

I doubt Mr. Pagaia is going to help you.

This is the 4th time you comes with this question. You received already the right answer - an official FAQ. If the question stays the same the answer will stay the same.

For the FAQ to work you should have:
1. Do a task as the CPU goes from STOP -> RUN
2. The tag where the HSC is stored must be set to retentive
3. Coding such as described in the FAQ using MOVE and CTRL_HSC instructions.

Your choices are:
1. Give up
2. Repost your question somewhere
3. Use the official Support Request service.
4. You publish your program in the forum for evaluation.
5. You send me per private message your program for evaluation.
6. Send me a private message with your email address and dropbox address where the project is.

Please let me know your answer in public forum if you go for 5 or 6, so I will check my private mail.

Regards.

ACDC24

Hi,Denilson Pegaia

Is it possible to enter a value in hmi for hsc in plc1200 when the power become off and on?Because when the power become off the counted value become zero and I want to enter value after power become on.

Thanks in advance

Closed cause question posted twice.

The second thread with the subject ENTER COUNTED VALUE OF ENCODER MANUALLY IN HSC is published within the conference STEP 7 (TIA Portal).

Best regards
Min_Moderator