Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

error 2000 840 c

Created by: 840c at: 3/23/2009 6:21 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

3/23/2009 6:21 PM	Rate (0)
840c Posts: 4 Rating: (0)	i have milling machine uses hitrol 840 c I have error 2000 message i checked my emeregency stopcircuit it works normally but i have emeregency stop message and i cannot power on the machine . i press reset and power on but emeregency message doesnot disappear and i cannot power on the machine
840c Posts: 4 Rating: (0)	Last edited by: 840c at: 3/23/2009 6:25 PM
Suggestion To thank Quote Answer

3/24/2009 4:03 PM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi Have you checked the hardware limit switches? Nit

Suggestion To thank Quote Answer

3/25/2009 12:19 AM	Rate (0)
Pee Ell Sea Posts: 672 Rating: (57)	Are there no other messages on the alarm page ?
Pee Ell Sea Posts: 672 Rating: (57)
Suggestion To thank Quote Answer

3/25/2009 8:49 PM	Rate (0)
tomas94 Bronze Member Joined: 10/2/2005 Last visit: 12/16/2024 Posts: 32 Rating: (1)	Hi,Check your transformer, maybe it not gives you 24 volt.RegardsTomas

Suggestion To thank Quote Answer

4/9/2009 8:34 AM	Rate (0)
840c Posts: 4 Rating: (0)	Dear Nit Thank you , It was y axis overtravel
840c Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

4/10/2009 2:30 PM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi Thanks accepted. I'm glad that you've solved the problem. Nit

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on