Hi,

    i need suggestion  for below ,

PLC 1(1214) -RS232-> SERIAL TO ETHERNET -> PLC2 (1214)

this is my communication model i just need to know what are the blocks i should and if there any sample program will helpful., in plc 1 side i used SENDPTP Block and receiver side i used TRECV but still i got error .,plz help me

----------------------------------------------------------------------------------------------------
Split from Communication via RS485 module.

Hi,

    i need suggestion  for below ,

PLC 1(1214) -RS232-> SERIAL TO ETHERNET -> PLC2 (1214)

this is my communication model i just need to know what are the blocks i should and if there any sample program will helpful., in plc 1 side i used SENDPTP Block and receiver side i used TRECV but still i got error .,plz help me

Hi,

    i need suggestion  for below ,

PLC 1(1214) -RS232-> SERIAL TO ETHERNET -> PLC2 (1214)

this is my communication model i just need to know what are the blocks i should and if there any sample program will helpful., in plc 1 side i used SENDPTP Block and receiver side i used TRECV but still i got error .,and i dont understand TCON  Parameters so plz help me

Closed cause question posted twice.

The second thread with the subject Connect receiver plc with ethernet is published within the conference Communication / Networks.

Best regards
Min_Moderator