ET 200M - analog output module not displaying error for wire break

Hi all,

I have Decentral Peripherie over Profibus in my project. I have configured Analog output 332-7ND02-0AB0 to perform diagnostic (common and group), and current output. From the software I set 10mA output and disconnect the wires, but SF LED does not tunr on, neither software diagnostic (SFC 59) shows any channel error, and no EXTF on the CPU (S7-414-5H). what am I missing? I have used this configuration many times and it always worked before.

Thanks in advance

Hello,

maybe you have missing some important OB blocks in your project.

Thanks for your reply,

this is the list of the OBs: 

CYCLIC OB OB      1 OB      1
Periodic Routine (FAST) OB     35 OB     35 Cyclic Interrupt 5
RED_I/O_FLT1 OB     70 OB     70 Redundancy I/O Fault 1
CPU RED ERR OB     72 OB     72
Time Fault OB     80 OB     80 Cycle Time Fault
PS_FLT OB     81 OB     81 Power Supply Fault
DIAGNOSTICS ALARMS OB     82 OB     82 I/O Point Fault
I/O_FLT2 OB     83 OB     83 I/O Point Fault 2
CPU_FLT OB     84 OB     84 CPU Fault
OBNL_FLT OB     85 OB     85 OB Not Loaded Fault
RACK_FLT OB     86 OB     86 Loss of Rack Fault
Communication Fault OB     87 OB     87 Communication Fault
BREAKUP ERROR OB     88 OB     88 Abortion of Processing
COMPLETE RESTART OB    100 OB    100 Complete Restart
COLD RESTART OB    102 OB    102 Cold Restart
PROG_ERR OB    121 OB    121 Programming Error
MOD_ERR OB    122 OB    122 Module Access Error

but how can the hardware diagnostic be related to the OBs? I think it is only a matter of hardware configuration

Hello,

Check that you have downloaded HW config to the CPU after your last modifications.

Check once again that the channel you break is set to current (4-20mA).

Still no solution for this issue. Could anybody please confirm that this module has the wire break diagnostic capability?

Hello,

basic question, what documentation about exact module shows?

Duris_I

Hello,

basic question, what documentation about exact module shows?

 Mistery solved. 7ND02 is the successor product for 7ND00. Previous product included wire break diagnostic, current product does not... Welcome to Siemens.

Changed to 5DH01, everything works fine

Hello,

probably problem with not correct situation explained. You've inform us that this cfg works previously ok, you did change this time from 00 to 02 version? This info you didn't post... This is also important for all of us that manual reading need to be MUST prior make some upgrade. Thank you for your info, helpful also to me.

I agree that information was not complete.. but 02 was declare as "successor" of 00.. Even though I would have read the manual, this info was hidden God knows where.. local Siemens representative found it for me..

Duris_I

Hello,

probably problem with not correct situation explained. You've inform us that this cfg works previously ok, you did change this time from 00 to 02 version? This info you didn't post... This is also important for all of us that manual reading need to be MUST prior make some upgrade. Thank you for your info, helpful also to me.