Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

ET200 safety - -HW config problems

Created by: Data block at: 11/14/2013 1:03 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

11/14/2013 1:03 PM	Rate (0)
Data block Posts: 81 Rating: (1)	Hello World, I have a program that have this Hardware: PLC CPU319-3PN/DP with profinet conection and some slaves....ET200S and Pro. I want to put inside a ET200 safety, a slave IM 151-8 F-CPU PN/DP, but when i try to drop him on my Hardware, this not function. Did i Need a rail??!? i dont Thing so.... Some Body can help?` In attachment you will find a Picture for understand better. Thanks for the help. Attachment Unbenannt.jpg (138 Downloads)
Data block Posts: 81 Rating: (1)
Suggestion To thank Quote Answer

11/14/2013 1:33 PM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 6/5/2023 Posts: 8587 Rating: (1127)	Hello, You need to start a new project (S7-300), insert the desired ET200S CPU. Insert the I/O modules and then you will have to generate GSD file Then you can insert in the "old" project the ET200S, by inserting the GSD file Hope this will help. Best regards, Wizard
	Last edited by: Wizard at: 11/14/2013 1:34 PM Last edited by: Wizard at: 11/14/2013 1:33 PM
Suggestion To thank Quote Answer

11/14/2013 1:48 PM	Rate (0)
Data block Posts: 81 Rating: (1)	Hello Wizard, Thanks for the reply. I understand.... I create a new Hardware with my safety device....know i want to create the GSD....but how can i do that? Thanks
Data block Posts: 81 Rating: (1)
Suggestion To thank Quote Answer

11/14/2013 2:03 PM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 6/5/2023 Posts: 8587 Rating: (1127)	Hello, In hardware configuration go to Options -> Create GSD file for I-device Best regards, Wizard

Suggestion To thank Quote Answer

11/14/2013 2:27 PM	Rate (0)
Data block Posts: 81 Rating: (1)	OK. Thanks again for your help.
Data block Posts: 81 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on