Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Et200s Serial Interface Module

Created by: k.k at: 3/4/2011 10:07 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

3/4/2011 10:07 AM	Rate (0)
k.k Posts: 40 Rating: (0)	Dear Sir, we are using Et200s SI module as a Modbus slave, As per the Manual in Chapter 3.6 I created S_Modb FB in OB 1 and Data conversion table in DB100. I like to know where Modbus data will be stored for communication, How to define? How Modbus address will be convert to Simatic address for send and receive, Is in slave part S_SEND & S_RECEV FB required. Pls anybody provideprocedure or Backup file for ET200S Modbus slave programming. Thanks & Regards KK
k.k Posts: 40 Rating: (0)
Suggestion To thank Quote Answer

3/4/2011 7:48 PM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 2/23/2023 Posts: 2685 Rating: (135)	Thread closed, because question is already discussed in the following thread Modbus Slave. Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on