hello

i would like to make connection to a drive from SMC (the JXCP1). this drive uses Profinet.

how can i configure this in the hardware i have an GSD file for this device, but when i install it i can't configure anything from this drive. are there any other functions i can use for this ?

thx

Nicolas Becue

Student Vives | Kortrijk -  Belgium

i found that the drive in and out puts are loaded in the global PLC tags.

playing with these parameters now to find the right settings ;)

Hello Nicolas,

I have the same problem. I use s7-1200 and JXCP1 SMC controller.

Should I change something in the JXCP1 properties?

Thanks: Gabor 

Hello everyone,

I have the same problem with JXCP1, can you please help me to set the parameters?

Best regards

M 

I use 6 axis and communication is not problem. We must activate drive and communication will be OK.

Without activation (enable), drive is connected but LEDs flashing red and signalized communication error, however drive still communicates. If you will activate drive to enable LEDs wiil be OK.